Switching Between Digital And Analog Audio (Input Mode) - Sony STR-DA3200ES Operating Instructions Manual

Switching between
digital and analog audio
(INPUT MODE)
When you connect components to both digital
and analog audio input jacks on the receiver,
you can fix the audio input mode to either of
them, or switch from one to the other,
depending on the type of material you intend
to watch.
1
3
90
GB
1
Press the input button.
You can also use INPUT SELECTOR on
the receiver.
2
Press RECEIVER.
Receiver operation is enabled.
3
Press INPUT MODE repeatedly
to select the audio input mode.
The selected audio input mode appears on
the display.
Audio input modes
• AUTO
Gives priority to digital audio signals when
there are both digital and analog
connections.
If there are no digital audio signals, analog
audio signals are selected.
2
• COAX
Specifies the digital audio signals input to
the DIGITAL COAXIAL jack.
• OPT
Specifies the digital audio signals input to
the DIGITAL OPTICAL jack.
• ANALOG
Specifies the analog audio signals input to
the AUDIO IN (L/R) jacks.
Notes
• You cannot select the digital audio input assigned
to another function using the DIGITAL ASSIGN
function (page 91).
• Some audio input modes may not be set up
depending on the input.
• When either HDMI input is selected, "------"
appears on the display, and you cannot select other
modes. Select an input mode other than the HDMI
input, then set the audio input mode.
• When the ANALOG DIRECT function is being
used, or MULTI IN is selected, audio input is set to
"ANALOG." You cannot select other modes.