Initial Startup - Vega Absolute SMART-SS0102 User Manual

Smart-SS0102 / User Manual

INITIAL STARTUP

Smoke sensor is powered by two CR123A 3V 1400 mAh replaceable batteries. The one
of them is main and the rest is reserve. While operating the device tests the batteries every
half an hour. As a result of test the device determinates operability and availability of batteries.
If both batteries are fine the device every time changes operation from the main battery (2
hours) and operation from the reserve battery (1 hour).
You need to insert the batteries observing the polarity before start. During this, the
reserve battery is installed first, then the main one. When the main battery is connected, the
device automatically switches to the "Standby" mode within a minute.
Two battery compartments are placed at the internal side of the housing.
Battery
compartments
After 60 seconds after inserting the batteries, the sensor starts working in the "Standby"
mode and performs its functions to detect smoke, regardless of the presence of registration
in the LoRaWAN network.
The sensor supports two activation methods in the LoRaWAN network - ABP and
OTAA. Select one of the methods using "Vega LoRaWAN Configurator" application (See part
4).
1. ABP. After inserting the batteries, the device immediately registers in the network.
2. OTAA. After inserting the batteries, the device makes three attempts to connect to
the network within the set frequency plan. After the activation request is confirmed by
LoRaWAN network, the device indicates it (blue LED and beep). If all attempts fail, the sensor
will keep trying to connect to the network every day. Meanwhile the sensor will function
normally in the "Standby" mode.
Revision № 04 - 03 June 2021
11