T-Fal KI1605US Manual page 7

2 Place the base on a flat, stable, heat-resistant surface
away from water splashes and any sources of heat.
• Your kettle must only be used with the base that matches it and its own anti-scale filter.
3 Fill the kettle with the desired amount of water. (fig 6)
• You can fill it through the spout, which ensures better maintenance of the filter. As a minimum,
cover the element (or the bottom of the kettle) with water.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full,
boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
• The kettle must always be used with its own anti-scale filter.
4 Position the kettle on its base. Plug it into the wall out-
let
5 For kettles that feature a temperature switch, select the
temperature according to your needs
• Right position
immediately. (fig 7)
6 To start the kettle
• Press the on/off button positioned on the top or the bottom of the handle according to the
model. (fig 8)
7 For kettles that feature a temperature switch
• If you move quickly from left position
the kettle has to reset itself. If you think that this is taking a long time, you can add cold water
to speed up the start of heating.
8 The kettle will switch off automatically
• As soon as the water reaches boiling point or the chosen temperature. You can stop it ma-
nually, before removing it from its base to pour the water. Depending on the model, the in-
dicator light will go out when the water reaches boiling point. Make sure that the on/off button
is in the off position after boiling and that the kettle has switched off before removing it from
its base.
Do not leave water in the kettle after use as this quickens the formation of scale.
for boiling water or left position for the ideal temperature for drinking
to right position after heating the water,
EN
5