Leveling The Laundry Center; Connecting The Water - Frigidaire FLCG7522AW Use & Care Manual

24
INSTALLATION
8. Attach the RED and BLACK power
cord conductors to the outer, BRASS
colored terminals on the terminal
block. Tighten both screws securely.
BLACK or RED BLACK or RED
power wires power wires
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT make a sharp bend or crimp
wiring/conductor at connections.
9. Follow manufacturer's guidelines for
firmly securing the strain relief and
power cord.
10. Reinstall the terminal block cover.

Leveling the laundry center

Excessive noise and vibration can be
prevented by properly leveling the
laundry center.
1. With the
laundry
center within
4 feet (1 m)
of its final
location,
place a level
on top of the washer lid.
2. Use
adjustable
pliers to
adjust the
leveling
legs so the
laundry
center is
level front-
to-rear and
side-to-side,
and stable corner-to-corner.
BRASS
terminals
raise
lower
3. Press down
on alternate
corners and
sides and
feel for the
slightest
movement.
Adjust the appropriate leg(s) so the
laundry center sits solidly on the
floor on ALL four legs. Keep the
leveling leg extension at a minimum
for best performance of the washer.

Connecting the water

1. Run some water
from the hot and
cold faucets to
flush the water
lines and remove
particles that
might clog the
water valve screens
and to determine
which faucet is hot
and which is cold
supply.
2. Check to ensure
that the inlet hoses
have the rubber
washer firmly in
place. Use only
new hoses.

NOTE
Hoses are not included with laundry
center purchase and must be
purchased separately.
3. Connect the
HOT inlet
hose to the
HOT inlet
connection
on the
washer and
the COLD
inlet hose to
the COLD
inlet connection on the washer (cold
on top).