Baxton Studio BECKER-FULL-DAYBED Assembly Instruction

NO PART LIST QTY
1 1PC
BACK REST
SIDE PANEL
1PC
2
(L)
SIDE PANEL
1PC
3
(R)
FRONT
1PC
4
SIDE RAIL
BACK
1PC
5
SIDE RAIL
6 4PCS
LEG
SLAT
7
2 SET
7pcs
CENTER
1PC
8
SUPPORT
SUPPORT
2PCS
9
LEG
ITEM HARDWARE QTY
JCBB SCREW
A 12PCS
M8 x 20MM
JCBC SCREW
4PCS
B
M6 x 35MM
JCBC SCREW
C 4PCS
M6 x 50MM
D
SPRING WASHER 4PCS
FLAT WASHER
E 4PCS
(BIG)
SCREW
F 14PCS
M4 x 32MM
L - KEY
G
1PC
M4 x 65MM
L - KEY
H 1PC
M5 x 65MM
Please do not tighten the hardware until the entire assembly is completed.
STEP 1
Begin assembly by attaching each Leg (6) to the bottom of the
Side Panel (2) & (3) securing with 2 Allen Bolt (B) per panel using
L-key (G).
L
2
B
G
STEP 3
Attach the Back Rest (1) to each Side Panel (2) & (3) by aligning the
hole and securing with 2 Allen Bolts (C), 2 Spring Washer (D), 2 Flat
Washer (E) per each end using L-key (G) as picture below.
(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
2
5
4
STEP 2
Attach the Front Rail (4) and Back Rail (5) to the Side Panel (2) & (3)
by aligning holes and securing with 2 Allen Bolts (A) per each end using
L-key (H). (DO NO T FULLY TIGHTEN BOLTS FOR THIS STEP)
R
3
6
STEP 4
Secure 2 Support Leg (9) to the Center Support (8) as shown on step 4.1.
Tighten the Support Leg (9) clockwise until secure. Insert the pre-set
metal on Center Support (8) to the metal bracket on each side of Side
Panel (2) & (3) as step 4.2. Then securing the metal bracket as shown in
step 4.3 with 1 Screw (F) each side using Phillips He ad Screwdriver
D
E
(NOT INCLUDED)
C
G
1
STEP 4.2
STEP 4.3
3
2 2 2 2
5 5 5 5
4 4 4 4
8
2
4
F
BECKER-FULL-DAYBED
BECKER-QUEEN -DAYBED
H
A
3 3 3 3
STEP 4.1
8
9
1
5
3