HoMedics HX-P303 Operation Instruction

HoMedics HX-P303 Operation Instruction

Advertisement

 
 
 
 
 
 
 
 
 
 
‐ button                Multifunctional button                Red/blue light                      +button           
 
 
 
 
 
 
 
 
 
 
 
HX‐P303 Operation instruction 
1
 

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HX-P303 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HoMedics HX-P303

  • Page 1 HX‐P303 Operation instruction                        ‐ button                Multifunctional button                Red/blue light                      +button             ...
  • Page 2               Usb charge port(5V/1000mA)          Aux in     ...
  • Page 3               Mic                                                                  Button function: ...
  • Page 4 POWER_ON_2017 (When power on)  SEARCHING_BLUETOOTH    (When pairing)  When battery is 3.4V,low battery prompt tone start to every 2.5 Minutes play one time .When battery  voltage less than 3.3V,will power off automatically.  Charge:use DC 5V/1000mA micro USB port charger to charge.    Bluetooth search name:  Hang Tight    When did not connect bluetooth for 2 minutes,will power off automatically.When connect bluetooth  successfully and did not play for 15 minutes will power off automatically.  Quiescent current: less than 15 uA    Bluetooth transmission range:not less than 30 meters.        FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.
  • Page 5 FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .   ISEDC WARNING This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Table of Contents