Table of Contents
Advertisement
en Troubleshooting
Fault
The programme does
not start.
The door cannot
be opened.
The water is not drain-
ing.
40
Cause and troubleshooting
Remove any trapped laundry.
2.
Close the door.
3.
Press Start/Reload to start the programme.
4.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 31
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 24
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 46
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 33
▶
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Pump cover is not correctly assembled.
Correctly assemble the pump cover.
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 15
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Advertisement
Table of Contents
