Brightz Wheel Instructions

Step 1 – Install Batteries
Open latches on the side of the battery pack to access batteries. Install 3 fresh AA batteries,
observing correct polarity (+/-). Close the battery pack, making sure the latches snap shut.
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable
(nicad, ni-mh, etc.) batteries.
Caution: Batteries may explode or leak, and cause burn injury if recharged, disposed of in fire, mixed
with a different battery type, or inserted backwards. Replace all used batteries at the same time.
Clean battery contacts and contacts on the device prior to installing. Remove batteries if item will not
be used for long periods of time. When battery expires remove promptly.
Step 2 – Install Battery Pack
Take the silicon strap and loop one of the end holes over the T-hook on the side of the battery pack.
Place the battery pack in the space between the spokes, between 2 cross sections, pull the silicon strap
around the cross section, and secure it tightly on the other T-hook. Any excess strap can be cut off.
Warning: Do not mount the battery pack near or on moving parts, or where it has the potential to
interfere with moving parts.
Spoke Cross
Section
Wheel Brightz
Instructions
Copyright Brightz, Ltd. 2018
©
Patent Pending • All rights reserved
™
Spoke Cross
Section