Advertisement
Set Autolock Time Delay
6
Enter PC
Remark : 10-99 seconds delay-time available.
Toggle Mute On/Off
7
Enter PC
Remark : Repeat same steps to turn beeper On/Off.
LED illumination is still functioning when it's in mute.
But there will be no any warning alarm.
Enable/Disable All User Code
Enter PC
8
Remark : Auto-locking and Keypad locking function will be invalid when User Codes
are disabled. The lock can only be operated by key during the time.
Repeat the steps to enable the User Codes again.
Create a disposable User Code
9
Enter PC
Remark : Disposable code will be no longer valid once being used.
Restore all preset lock settings
R
Press
Remark : Press "R" button for over 5 seconds, the programming will complete after
you hear 3 long beeps.
After restore, you need to run the door handing identifying process before
other function setting.
Programming Code (PC)
■
Simple Troubleshooting
USER Code (UC)
Situation 1
After the installation of the lockset and batteries, the door cannot
Enter Seconds
be locked and three short beeps are emitted when you press the
(10~99)
Programming button.
Causes
: The door-handing indentifying process is not yet complete.
Solutions
Situation 2
After the installation of the lockset and batteries, no responses
when you press any button (no sounds are emitted, and the back
light does not work).
Causes
: It could be a problem caused by the batteries or the improper connection of
Solutions
Situation 3
Fail in the first execution of the door-handing indentifying process
(the red light flashes three times, and three short beeps are emitted).
Causes
: Wrong door-handing or change of the door-handing in the memory.
Enter new
Solutions
disposable
UC
Situation 4
Although succeeded in the first execution of the door-handing
indentifying process, the latch does not work.
(Feeling that the motor runs powerlessly, the latch bolt is stuck,
and the turn-piece inside cannot be rotated.)
Causes
: Low battery.
Solutions
11
: Please execute the door-handing indentifying process as soon as the
installation of the lockset is completed.
the cable.
: Check to see if the battery polarities have been reversed or if the battery is
dead. If so, please re-install or change the battery. If not, please check if
the cable is appropriately connected.
: Press the R button to restore the system to factory default setting and
re-execute door-handing indentifying process.
: Please replace with new batteries.
12
Advertisement
