Advertisement
Programming Button
Programming Button is for entering codes, clearing errors and setting function.
It's also lock button.
Number Buttons
Input the pass codes, each pass code is 4-10 digits in length.
Cylinder
Retract / Extend the latch bolt by key from exterior.
Washer
Prevent water permeating into lockset.
Battery Lid
Slide the lid to change the batteries or restore default setting.
Battery Holder
(
)
Four AA 1.5V Alkaline batteries.
R Button (Reset)
Restore default setting.
Turn-Piece
Retract/Extend the latch bolt from interior.
■ Specification Function
/
1.Battery
Four AA 1.5V Alkaline batteries.
(
)
2.Low Battery
2-1 The batteries should be changed immediately once you see the LED flashes in red
and hear constant beep sounds for about 10 seconds when press programming
button.
2-2 All settings are retained in the memory and will not be affected even if the battery
is completely dead.
2-3 The lock still can be operated by key even there is a power outage.
3.LED Indicator
3-1 LED flashes green once when successful operation.
3-2 LED flashes green twice when successful programming.
3-3 LED flashes red 3 times when there is an operation error.
3-4 LED flashes red 5 times when codes input error, the operation will stop for system
protection (Refer to 17).
3-5 LED flashes orange 3 times when system has been restored to default setting.
3-6 LED flashes orange slowly while in programming mode.
4.Audio Indicator
4-1 1 beep sound indicates a successful operation.
4-2 2 long beeps indicate a successful programming
4-3 3 beeps indicate an operation error.
4-4 3 long beeps indicate that system has been restored to default setting.
4-5 5 beeps when codes input error, the operation will stop for system protection.
(Refer to 17)
4-6 10 rapid beeps indicate the power of battery is low.
5.Programming Code
5-1 The preset Programming Code is 0000. Please delete it and create your personal
code when first time operation.
5-2 Only one set of Programming Code for function setting.
5-3 Programming Code is only for function setting, you can't unlock the door by
pressing Programming Code.
5-4 Programming code is 4-10 digits in length.
5-5 Programming code can be changed anytime if needed.
5
6
Advertisement
