Page 3
The container being cleaned should be sealed as best as possible while the TankJet 80 models are running its cycle. The combination of temperature, cleaning solution, spray impact and the potential toxic materials being cleaned can cause a...
Many types of fluids, sanitizers, detergents, solvents CONSTRUCTION: and caustics may be used through the TankJet 80 to assist in its cleaning effectiveness. Referring to the Parts List, the unit consists of two basic Caution: If chemicals, hazardous materials, operations, components;...
INSTALLATION TROUBLE SHOOTING The TankJet 80 or TankJet 80H is easy to install as it has a Due to the simplicity of the unit, very few problems should single 1-1/2" female pipe thread connection (NPT or BSPT). It occur. If any trouble should arise, the following steps may be may be installed on a tripod, suspended from a pipe, manhole taken: Refer to the Parts List.
Install the nozzle extension (22) with the nozzles (19) into TANKJET 80 ASSEMBLY the nozzle body (18) and torque to 80 ft./lbs. Be sure to use caution when handling the TankJet 80. When holding, make sure the nozzles are tightly screwed on the unit WARRANTY and then hold the unit from its nozzle not the body.
SPECIFICATIONS 80-2 80-3 MINIMUM TANK OPENING MINIMUM TANK OPENING Ø12.5 in. Ø 6.5 in. (Ø217.5 mm) ACROSS FLATS (Ø165.1 mm) 2.12 in. (53.8 mm) 5.50 in. (139.7 mm) ACROSS FLATS 2.12 in. (53.8 mm) 5.50 in. 1.5 in. NPT (139.7 mm) 1.5 in.
12/7/2020 Wheaton, Illinois, USA EC DECLARATION OF INCORPORATION Spraying Systems Co. ® North Avenue and Schmale Road, P.O. Box 7900, Wheaton, IL 60187-7901 Tel: 1.800.95.SPRAY Intl. Tel: 1.630.665.5000 Fax: 1.888.95.SPRAY Intl. Fax: 1.630.260.0842 Visit our Website at http://www.spray.com for local representatives...
Need help?
Do you have a question about the TankJet 80 and is the answer not in the manual?
Questions and answers