The container being cleaned should be sealed as best as possible while the TankJet 75 models are running their cycle. The combination of temperature, cleaning solution, spray impact and the potential toxic materials being cleaned can cause a hazard to anyone in the path of the spray.
Standard Nozzle: 0.125 TJ75H*-4-125 45 revolutions. The TankJet 75-2 and the 75H-2 are specifically PSI: 150-300 | GPM: 15-21 | NPT designed for 3" dia. openings, care must be exercised during Standard Nozzle: 0.172...
INSTALLATION TROUBLESHOOTING The TankJet 75 is easy to install as it has a single 3/4" female Due to the simplicity of the unit, very few problems should occur. ® pipe thread connection (NPT or BSPT) or 1" sanitary tri-clover If any trouble should arise, the following steps may be taken: flange fitting.
REPLACEMENT PARTS ASSEMBLY When the machine requires replacement parts, only Spraying Be sure to use caution when handling the TankJet 75. When Systems Co. recommended components should be used to holding, make sure the nozzles are tightly screwed on the maintain proper machine operation and safety.
OR BETTER FRAC. .XXX DEC. .XX DEC. ANG. This drawing is the sole and exclusive property of Spraying Systems Co. This license is for use only by the Licensee and only in connection with an accompanying ECO No. PROJECT No.
Need help?
Do you have a question about the TankJet 75 and is the answer not in the manual?
Questions and answers