Table of Contents
Advertisement
Figure 20. Aligning and engaging the pins into the holes in the rear of the rack
4. Reinstall the screw that was removed in step 2 on page 21, as shown in Figure 21.
Figure 21. Reinstalling the screw
5. Return to the front of the rack. Ensure that the latch is still open on the front of the slide rail. Refer to
step 2 on page 21.
6. Pull the slide rail forward and insert three pins on the front of the rail into the holes within the
selected EIA unit that were previously marked. Lower the slide rail down (1) to engage the hook
feature on the middle pin. For details, see Figure 22.
Figure 22. Pins that are seated on the front rail of the rack
22
Power Systems: Installing the IBM Power System S822L (8247-22L)
Advertisement
Table of Contents
