Fanimation AireDrop LP7654LBL Manual page 9

How to Assemble Your Ceiling Fan (Continued)
4. Thread downrod into the downrod support on top
of the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with locking nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white and blue wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
8. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Downrod
Set Screws and
Locking Nuts (2)
Ceiling Canopy
Canopy Screw
Cover
Hanger Bracket
9
Hairpin Clip
Clevis Pin
Figure 4
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7
Figure 8