Advertisement
Quick Links
Operation Manual
Mortar Mixer with Single Stirrer
62354
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Summary of Contents for WilTec 62354
- Page 1 Operation Manual Mortar Mixer with Single Stirrer 62354 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Always wear protective goggles when using this tool to avoid injury from particles falling off or being blown up. Always wear hearing protection when using this tool. © by WilTec Wildanger Technik GmbH Item 62354 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 Remove all adjusting wrenches and other wrenches before switching on the tool. An adjust- ment wrench or another wrench on a moving part can cause serious injury. © by WilTec Wildanger Technik GmbH Item 62354 Page 4 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 Be careful when using cleaning agents and solvents as gasoline, carbon tetrachloride, ammo- nia, and chlorinated or ammonia-containing household cleaners can severely damage the plastic parts of the tool. © by WilTec Wildanger Technik GmbH Item 62354 Page 5 http://www.WilTec.de http://www.aoyue.eu...
- Page 6 First disconnect the device from the power supply, remove the motor housing (see Fig. 1). b) Pull out the plate and replace the carbon brush (see Fig. 2). © by WilTec Wildanger Technik GmbH Item 62354 Page 6 http://www.WilTec.de...
- Page 7 4. Place the stirrer on the discharge shaft (see Fig. 4). 5. Tighten the screw of the stirrer (see Fig. 5). Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 © by WilTec Wildanger Technik GmbH Item 62354 Page 7 http://www.WilTec.de http://www.aoyue.eu 04 2021-1 http://www.teichtip.de...
- Page 8 The electronic speed regulator allows the speed of the stirring staff to be further adjusted during oper - ation by simply turning it. Figure 6 Figure 7 Stopping Release the start switch; this will stop the machine. Figure 8 © by WilTec Wildanger Technik GmbH Item 62354 Page 8 http://www.WilTec.de http://www.aoyue.eu 04 2021-1 http://www.teichtip.de...
- Page 9 All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.