Table of Contents
Advertisement
• DYNAMIC RANGE
When "LINE OUT" is selected, choose this setting to adjust the line out ratio and get different
effect. If adjusting to FULL, the audio signal peak value will be the minimum; while adjusting to
OFF, maximum.
Note :
This option will be validated when the DOWNMIX OFF.
• DUAL MONO (LEFT + RIGHT)
Choose this option to setup the L and R mono output mode; There are four modes in this option :
STEREO, MONO L, MONO R, and MIX MONO; It is mainly used in karaoke mode.
REFERENCE :
– To protect your DVD player, the interval between two consecutive Power button operations
must be above 30 seconds.
– No using for a period of time, please pull out the plug from the electronic outlet.
– The player should be operated only on condition that the type of power supply corresponds to
the marking label. Otherwise, it doesn't work or even be damaged.
– The player may not be compatible with some encrypted discs.
– If the player stops playback by accident, please power it on again.
Clock Setting
In standby or any source mode
1. Press and hold CLOCK key on the remote control for more than 2 seconds to enter into the
clock setting mode, the " SYNC ON " or " SYNC OFF " will show on the display.
2. Press PRESET
–
" SYNC ON " active RTC function of RDS, the time will update automatically when received the
correct signal.
BASIC SETUP
AUDIO SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
EXIT SETUP
AUDIO SETUP
OP MODE
DYNAMIC RANGE
DYNAMIC RANGE
DUAL MONO
EXIT SETUP
CLOCK / TIMER
/
or PRESET
FULL
OFF
STEREO
MONO L
MONO L
MONO R
MONO R
MIX MONO
MIX MONO
/
to select ON or OFF for the SYNC.
GB–22
6/8
4/8
2/8
Advertisement
Table of Contents
