Table of Contents
Advertisement
7 Put back the parts you removed in previous steps:
a Put back the ventilation duct cover, and fasten the 3 screws you removed in step 5.
b Connect the cables numbered 5 and 6 you unplugged in step 4.
c Put back the beam, and fasten the 4 screws you removed in step 3.
8 Put back the rear top cover you lifted in step 2.
a Align the round dots at the side of rear top cover with the slots on the chassis' edge, and push the rear top
cover back in position.
b Put back and fasten the screw you removed in step 2-a.
To make sure FlashStation recognizes the new memory capacity:
1 Log in to DSM as admin or a user belonging to the administrators group.
2 Check
Total Physical Memory
If your FlashStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
To remove the RAM Module:
1 Follow step 1 to 5 of the "To install the RAM module" section to shut down your FlashStation, disconnect the
cables, lift the rear top cover, and then remove the covering parts.
2 Disengage the memory retaining clips by pushing them outwards, and the module will pop out of the slot.
3 Follow step 7 and 8 of the "To install the RAM module" section to put back the covering parts and top cover.
11 Chapter 2: Hardware Setup
in
Control Panel
>
Info
Center.
Advertisement
Table of Contents
