Federal Communications Commission Interference Statement - Panasonic EYFLA6PR Operating Instructions Manual

VII
. ACCESSORIES
Charger
• EY0L80
• EY0L81
Battery pack
• EYFB30
• EYFB40
Remote control
• EYFA30
Federal Communications Commission Interference
Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assume continued compliance, install and use in accordance with provided
instructions. Use only the battery pack specified in the instructions. Any changes or modifications
not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept
any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Panasonic Electric Works Power Tools Co., Ltd.
33, Okamachi, Hikone, Shiga, Japan
FCC ID: O4O­EYFLA
Protector for tool
• EYFA01-A (Blue)
• EYFA01-Y (Yellow)
• EYFA01-H (Gray)
• EYFA01-G (Green)
Protector for battery
• EYFA0-H
• EYFA04-H
Assembly Qualifier
• EYFRZ01
• EYFR0
IC : 8507A­EYFLA
- 17 -