Sony BRAVIA KDL-46V3000 Operating Instructions Manual page 172

6: Performing the initial
setup
Selecting the language and country/
region
1
Connect the TV to your mains socket
(220-240 V AC, 50 Hz).
2
Press 1 on the top edge of the TV.
When you turn on the TV for the first time, the
Language menu appears on the screen.
3
F f G g
Press / / /
displayed on the menu screens, then press
.
6
GB
3,4,6,7
9
to select the language
4
F f
Press / to select the country/region in
which you will operate the TV, then press
.
If the country/region which you want to use on the
TV does not appear in the list, select "-" instead of
a country/region.
Auto tuning the TV
5
Before you start auto tuning the TV, insert
a pre-recorded tape into the VCR
connected to the TV (page 5) and start play
back.
The video channel will be located and stored on
the TV during auto tuning.
If no VCR is connected to the TV, skip this step.
6
G g
Press / to select "OK", then press
7
F f
Press / to select "Antenna" or "Cable",
then press .
If you select "Cable", the screen for selecting the
scan type appears. See "To tune the TV for digital
cable connection" on page 7.
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, so do not
press any buttons on the TV or remote while
proceeding.
If a message appears for you to confirm the aerial
connection
No digital or analogue channels were found.
Check all the aerial connections and press
start auto tuning again.
8
When the Programme Sorting menu
appears on the screen, follow the steps of
"Programme Sorting" on page 33.
If you do not wish to change the order in which the
analogue channels are stored on the TV, go to next
step.
.
to