Stanley Fatmax SXPW2823K Instruction Manual page 23

OPERATIONAL
ISSUE
Will not draw
chemicals
No or low
pressure (after
period of
normal use)
Water leaking
at gun/spray
wand connection
Water leaking
at pump
Pump pulsates
POSSIBLE CAUSE
Air in hose
Choke in the
"Choke" position
High pressure hose
is too long
Spray wand not in
low pressure
Chemical filter clogged
Chemical screen not
in cleaning solution
Chemical too thick
Pressure hose is too long
Chemical build up in
chemical injector
Worn seal or packing
Worn or obstructed valves
Worn unloader piston
Worn or broken o-ring
Loose hose connection
Loose connections
Piston packings worn
Worn or broken o-rings
Pump head or tubes
damaged from freezing
Nozzle obstructed
SOLUTION
Turn off the engine, then the water
source. Disconnect the water source
from the pump inlet and turn the
water source on to remove all air
from the hose. When there is a
steady stream of water present,
turn water source off. Re- con nect
water source to pump inlet and
turn on wa ter source. Squeeze
trigger to re move re main ing air
Move choke to the "No
Choke" po si tion
Use high pressure hose
under 100 feet (30 m)
See How to Use Spray Wand
paragraph in the Operation Section
Clean filter
Make sure end of detergent
siphon hose is fully submerged
into cleaning solution
Dilute chemical. Chemical should
be the same consistency as water
Lengthen water supply hose
instead of high pressure hose
Please contact our customer service
department at 1-877-362-4271
Please contact our customer service
department at 1-877-362-4271
Please contact our customer service
department at 1-877-362-4271
Please contact our customer service
department at 1-877-362-4271
Check and replace
Tighten
Tighten
Please contact our customer service
department at 1-877-362-4271
Please contact our customer service
department at 1-877-362-4271
Please contact our customer service
department at 1-877-362-4271
See Nozzle Cleaning paragraph
in the Maintenance section
for the correct procedure
23 - ENG