Warnings; Location And Installings - Blaze BLZSSRF-15 Manual

Location and Installing Your appliance
The appliance should be installed in accordance with local electrical code requirements. It should also
be placed in a location that is strong enough to support its total weight, keeping in mind that it will
weigh substantially more when fully loaded than when empty.
Before you plug the appliance into a power supply, be sure to let it stand upright for at least 24
WARNING: Use two or more people to move and install the appliance. Failure to do so can result in
back or other injury. Carefully remove the packaging materials. Remove any shipping tape and glue
from your appliance before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage the surface of your appliance.
• Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a
soft, dry cloth and the inside with a lukewarm wet cloth.
• Place the appliance on a floor that is strong enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this
can increase electrical consumption. Extreme cold ambient temperatures may also cause the
appliance to perform improperly.
• Do not use the appliance near water, for example in a wet basement or near a sink.
• Before connecting the appliance to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
There is an adjustable leg on the bottom of the appliance that can be turned up or down to ensure that
the appliance is level. It is important that the appliance is level to minimize noise and vibration. To level
the appliance:
2. Turn the leveling leg counter - (clockwise) until it is touching the bottom of the chassis.
3. Once in place - slowly turn the leveling leg counterclockwise until the appliance is level.
hours to allow the compressor's oils to settle.
Cabinet Leg Adjustment
1. Move the appliance to its final location.
6
www.blazegrills.com