Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Program; Drying Takes Too Long - Asko PROFESSIONAL TDC145VS Operating Instructions Manual

TROUBLESHOOTING

NOTE!
When starting the tumble dryer for the fi rst time or
after a long period without use, you may notice a slight
thumping noise. This noise is completely normal and
will disappear after a few loads.

THE MACHINE WILL NOT START

Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been selected.
To cancel Delayed Start, press the Stop button for 3
seconds.
• that the plug is connected.
• that the main fuses have not blown.
• that the overheating cut-out has not been triggered.
WARNING!
If the lint fi lter not is cleaned regularly, the machine's
automatic overheating cut-out may be triggered
because of to high temperature. The heaters in the
machine will then switch off and the drum will continue
to spin to cool down the machine.
Call the service division if:
• Heating fault appears on the display.
• Max program time is shown frequently in the display
and the laundry does not get dry.
THE MACHINE LOSES ALL POWER
DURING A PROGRAM
The overheating cut-out shuts off the tumble dryer if the
temperature is too high, e.g. because dust is clogging the
lint filter.
• Clean the lint fi lter
• Wait until the machine has cooled then try starting it. If
it still does not start: Call the service division.

DRYING TAKES TOO LONG

• Check that the lint fi lter is not blocked. See the Care
and cleaning chapter.
14

ERROR MESSAGES

• Read Drying takes too long in this chapter if Max
program time appears on the display.
• If Clean Lint Filter appears on the display, clean the lint
fi lter.
• Call the service division if Thermistor fault appears on
the display.
• Press the Stop button to close any error messages.