Advertisement
(C-9195KD) LEG CURL EXTENSION
ASSEMBLY INSTRUCTIONS
THIS UNIT IS BULKY, HENCE TWO PEOPLE ARE REQUIRED TO ASSEMBLE THE UNIT.
TOOLS REQUIRED: (1) 17mm and (1) 9/16" WRENCHES. DO NOT TIGHTEN HARDWARE
(HAND TIGHT ONLY) UNTIL INSTRUCTED.
ATTACHING (1) FRONT SECTION TO (1) REAR SECTION: FOR BOTTOM JOINT: PLACE (1)
INSERT INSIDE 2" SQ. TUBES, (2) BRACES OUTSIDE AS SHOWN WITH (2) 3/8" X 3"
BOLTS, (4) 3/8" FLAT WASHERS AND (2) 3/8" LOCK NUTS. FOR TOP JOINT: PLACE (1)
INSERT INSIDE 2" SQ. TUBES, (2) HANDLES OUTSIDE AS SHOWN WITH (1) 3/8" X 3-1/4"
BOLT and (1) 3/8" X 3" BOLT, (4) 3/8" FLAT WASHERS AND (2) 3/8" LOCK NUTS.
ATTACH (1) REAR FOOT TO REAR SECTION AND (1) FRONT FOOT TO FRONT SECTION
WITH (6) 3/8" X 3" BOLTS, (12) 3/8" FLAT WASHERS AND (6) 3/8" LOCK NUTS.
NOTE: ATTACH OUTSIDE (4) CAPS TO FRONT & REAR FOOT IF NOT ALREADY
ATTACHED.
ATTACH FRONT AND REAR SEATS TO THE MAIN FRAME WITH (4) 3/8" X 3" BOLTS AND
(4) 3/8" FLAT WASHERS.
ATTACH LEG CURL ATTACHMENT TO THE MAIN FRAME WITH (1) 3/8" X 3"
BOLT, (2) 3/8" FLAT WASHERS AND (1) 3/8" LOCK NUT.
(using longer bolt can scratch your thigh)
INSERT (1) CUSHION BAR THROUGH MAIN FRAME, PUSH (2) ROUND CUSHIONS ON TO
CUSHION BAR AND SECURE WITH (2) 3/8" X 1" BOLTS AND (2) 3/8" LARGE WASHERS.
INSERT (2) TOP & BOTTOM CUSHION BARS INTO LEG CURL. PUSH (4) CUSHIONS ON
TO CUSHION BARS, THEN SECURE WITH (4) 3/8" X 1" BOLTS AND (4) 3/8" LARGE
WASHERS.
CHECK THE UNIT ON A LEVEL SURFACE TO MAKE SURE THE UNIT IS LEVEL, CENTER
THE SEATS AND LEG CURL ATTACHMENT. THEN TIGHTEN ALL BOLTS AND NUTS.
IMPORTANT: PLACE SMALL WEIGHTS ON PLATE HOLDER TO START.
HARDWARE:
(15) 3/8" X 3" BOLTS
(6) 3/8" X 1" BOLTS
(36) 3/8" FLAT WASHERS
(11) 3/8" LOCK NUTS
(6) LARGE WASHERS (for cushions)
(6) CUSHIONS
(4) 2" OUTSIDE FEET
(4) 2" INSIDE PLUGS (PRE-INSTALLED)
(1) 3/8" X 3-1/4" BOLT
TDS Fitness Equipment
022020
Page: 3 of 3
Advertisement
