Table of Contents
Advertisement
Troubleshooting
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem: refer to the "Panasonic / Technics Accessory Limited
Warranty" on page 29. Take the unit when you visit your dealer.
Problem
I can't hear any sound.
The sound is barely
audible.
I hear a lot of noise.
The sound keeps breaking
up.
The unit doesn't work.
I can't register the (pairing
of the) device.
I can't use my cellphone
to communicate.
Possible cause and suggested remedy
• Something is wrong with the wireless communication.
• Is power being supplied to the unit and device connected to it? (Is the unit's lamp
blinking in blue?)
•Have you temporarily suspended play using the receiver or iPod
• Has the transmitter been inserted all the way into the docking connector of the iPod
• Is the transmitter's connector dirty?
• Has the input plug of the stereo earphones been inserted all the way (into the
AUDIO OUT connector)?
• Is the plug dirty?
• Noise may be heard due to the effect of the cellphone.
• Depending on the specifications and settings of your cellphone, the sound may break
up or data communication may not be possible when you operate your cellphone.
• Is a Bluetooth-enabled device other than this unit being used? Do not use the two
devices at the same time.
• Has the battery in the receiver or the device connected discharged? If it is, recharge it.
• No power is supplied while the unit is being charged.
• Connect the transmitter firmly to your iPod
information is not erased by this operation.) Then perform the pair setting again.
* Reset operation: Insert a paper clip or other thin rod-type object into the hole on
the receiver and press until there is the feeling of a button being pressed.
• Did you allow more than one minute to elapse after setting the unit to the device
registration mode? The pair setting is automatically released if you allow more than
one minute to elapse.
• Set the pairing with the unit and connected device placed as close to each other as possible.
• Is your cellphone set to auto response or answering machine mode?
• Have you set the volume level for the incoming tone and for receiving calls too low?
®
?
®
, and reset the receiver. (The pairing
®
?
25
Advertisement
Table of Contents
