Table of Contents
Advertisement
Troubleshooting
Problem
The rechargeable battery is
hot while it is being charged. The battery will become somewhat hot: this is normal and not indicative of trouble.
I can't connect a device
even though I have
already registered it.
Charging is not terminated
even though the time for
a complete charging has
elapsed.
Charging stops
26
immediately.
Possible cause and suggested remedy
<iPod
>
®
• Re-register the transmitter and receiver pairing.
1, Connect the transmitter to the iPod
2, Press and hold the transmitter button for 2 seconds.
The transmitter's lamp (red) starts blinking rapidly.
3, Press and hold the MIC button on the receiver for 2 seconds.
The receiver's power is now turned on, and the lamp (red) blinks slowly.
4, Press and hold the [–] button on the receiver for 6 seconds.
The receiver and transmitter lamps (red) start blinking rapidly.
• When re-registering the pairing: Wait for about 7 seconds. Step 5 is not necessary.
• When registering the pairing for the first time (when replacing the unit with a
new one): Go to step 5.
5, Press the transmitter button twice quickly.
When the pair setting has been re-registered, the transmitter lamp (blue) and
receiver lamp (blue) will blink slowly.
If failed, power off both devices and try again.
<Cellphone>
Re-register the cellphone and receiver pairing. Refer to "Registering the device pair"
on page 18.
This process may take approximately 3 hours or so depending on the level of the
battery's remaining charge.
To prevent overcharging, repeated charging is not possible.
Before charging again after fully charging, use the unit for at least 20 to 30 minutes.
(If charging is restarted immediately after fully charging, charging will automatically
stop after about 1 minute.)
®
.
Advertisement
Table of Contents
