Settings; Distance/Auto Setup/Input Mode - Panasonic SC-HT56 Operating Instructions Manual

Settings

Change the settings to suit your equipment
to the environment in which you are using
it. Before making any changes, read the
descriptions of the settings, note the factory
settings and ranges, and refer to the
equipment's instructions.
Enter the
1 2
setup mode.
2a
DISTANCE ↔ AUTO SETUP ↔ INPUT
MODE ↔ HDMI ↔ DRCOMP ↔
ATTENUATOR ↔ REMOTE ↔ TV DELAY ↔
RESET ↔ EXIT
Press and hold.
2b
Note
Auto speaker setup calibration will give optimal result for "DISTANCE". Therefore, you are unable to adjust the setting manually.
• Enter the distance of the front, center and surround speakers from
Distance
the seating position.
Change the distance so that the sound from all the speakers (except for the
subwoofer) reaches you at the same time.
You can select distances between 3 feet and 30 feet.
The factory settings are:
LR (front):
C (center):
S (surround):
• Reset the settings done in auto speaker setup.
Auto setup
YES: Reset all auto speaker setup settings
NO: To cancel (factory setting)
• This unit automatically detects whether input is digital or
Input mode
analog, but you can fix the input mode.
AUTO: The unit automatically detects whether input is digital or analog.
(factory setting)
ANALOG: Select to make the unit accept analog input.
DIG: Select to make the unit accept digital input.
PCMFIX 1 : Select to input to PCM.
1
In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginning of tracks to be cut off.
Select "PCMFIX" if this occurs.
• With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.
To engage the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time. "DTS" lights.
To cancel the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time.
The mode cancels when input mode is set to AUTO or when the unit is turned off.
Note
When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an
input mode other than PCMFIX, or cancel the DTS FIX mode.
Switch on.
Select the item you want to change.
Select and press [ENTER].
• Refer to pages 13 and 14 for each item settings.
• For "REMOTE", refer to page 21.
• For "RESET", refer to page 19.
Select and press [ENTER].
10 ft (feet)
10 ft (feet)
5 ft (feet)
Display
Change the Exit the
3 4
setting. setup mode.
Press to change the
P r e s s r e p e a t e d l y
setting.
until "EXIT" appears.
Press once to enter. Press [ENTER] to
completely exit the
setup mode.
2a 2b
DISTANCE LR
C
S
Repeat for each speaker channel
AUTO SETUP DEFAULT
INPUT MODE TV
DVR
DVD
(continue on next page)
3
3 feet to
30 feet
NO
YES
AUTO
ANALOG
DIG
PCMFIX
13