Advertisement
Quick Links
Advertisement
Related Manuals for Jegs 41535
Summary of Contents for Jegs 41535
- Page 1 Installation Guide for 41535 Fuel Gauge Interface Module 73-10 Ohm Sender to 0-90 Ohm Gauge...
- Page 2 Read Before Installation Wiring Thank you for purchasing this 73-10 to 0-90 ohm • RED: Connect to 12 volt ignition-on wire so fuel gauge interface module. the module has power when the vehicle is on. This module can be used on vehicles with a dissimilar •...
- Page 3 Store Mode IMPORTANT: To avoid hysteresis error, program the Full position first, then the Half position, then the Empty position (i.e. move sender from Full to Empty when programming). Some gauges are very slow to move, allow time for the gauge to stabilize. 1.
- Page 4 Power On Mode The Power On Mode allows you to program the position of the fuel level gauge pointer when the vehicle is started. 1. Turn the module power off and wait at least 5 seconds. 2. Program the desired POWER ON mode option (A or B): A.