Advertisement
Quick Links
Advertisement
Related Manuals for Jegs 90098
Summary of Contents for Jegs 90098
- Page 1 User Guide for 90098 Cargo Carrier 18 Cu.Ft. (510 cm...
-
Page 2: Table Of Contents
Table of Contents Parts List..............02 Read Before Installation........03 Caution..............03 Installation..........04-07 Locks............04 Lock Orientation..........04 Crossbars..........05-06 Locking Carrier Open........06 Mounting............07 Loading and Securing......07-08 Warning............08... -
Page 3: Parts List
Parts List (1) Rooftop Carrier [18 cu-ft] (4) Mounting Back Plates (1) Caution Sticker (4) Mounting Brackets (8) Threaded Knobs (2) Keys... -
Page 4: Read Before Installation
Caution Read Before Installation Thank you for your purchase of this JEGSPORT • Prior to assembly and installing the cargo 18 cu-ft Cargo Carrier. carrier carefully read and follow all instructions. Assembly and installation is your responsibility. Before installation, please be sure to verify that all of The manufacturer’s warranty is exclusively limited the kit components have been received. -
Page 5: Installation
Installation Step 1 Step 2 Front of Base Lock cam is in slot behind the bottom shell. Back of Base Place and align top shell on bottom, make sure all four lock cams are in the unlocked position and corresponding slot Lock cam is not in slot and not behind bottom shell. - Page 6 Installation Cont. Step 3 Step 4 24 in. Spacing Bottom Shell Openings Place the top shell on the bottom shell, being sure Set cross rails at 24” on center. (See Note) to line them up so that all four lock cams go through the bottom shell openings.
- Page 7 Installation Cont. Step 4 Cont. Step 5 Use closest upright to open side. Be sure to align the mounting holes in the bottom box on each side of the cross rails. Use ball stud closest to opening side. 1. Crossbar Spread •...
- Page 8 Installation Cont. Step 6 Step 7 Mounting Bracket Place the mounting bracket (#5) through the pre- Load cargo carrier paying careful attention to drilled holes from below the vehicle cross rails as distribute the weight evenly and not exceed shown above. the maximum allowed weight of the box or cross rails.
-
Page 9: Warning
Installation Cont. Warning Step 7 Cont. Check that the bale latche is closed and secured. Test that lid will not lift up when pulled. All four locks must be engaged, and keys removed, whenever the vehicle is in motion. Unlocked Locked Close top lid and place cam locks into their slots.