Simple Setup - Panasonic SC-HT830V Operating Instructions Manual

Simple setup

1
STEP Front speaker assembly
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and pipes.
2kFront 4kPipes
speakers
2kPipe A
(with a cable)
1
Attach pipes B to the bases.
A
Insert pipe B.
Match these holes when
you insert the pipe.
B
Secure pipe B to the base.
Ensure the screws are securely fastened.
2
Assemble the pipes.
A
Thread the speaker cable from Pipe A through Pipe B
and the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the pipe, and then
pull the rest of the cable through the base.
Pipe B
B
Join Pipe A to Pipe B.
Pipe B
Cable
C
Secure the pipes.
Ensure the screw is securely fastened.
Pipe B
[Note]
You can use the front speakers without assembling with the stands. In this case, attach the included
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move or
fall over. Use 4 pads per speaker.
2kBases
2kPipe B
Pipe B
Base
Washer screws
Phillips-head
screwdriver
Cable
Pipe A
Small screw
Pipe A
The supplied stands are specially designed for
attachment to Panasonic SB-FS730 front speakers.
Use only as indicated in this setup.
4kWasher 4kBracket 2kSmall
screws screws screws
3
Attach pipes A to the speakers.
Slot the screw head in between the 2 stoppers of the speaker
groove.
Align the screw head with the speaker groove.
Ensure the pipe is fastened on straight by gradually tightening the right
and left screws alternately until fully tightened.
To prevent short-circuit, do not cover the connection terminals
with the pipe.
Pipe A
Front speaker
4
Connect the speaker cables.
Twist the vinyl tip and pull off.
≥If the cords do not have vinyl tips,
directly connect them to the terminals.
_:
White
`:
Blue
5
Secure the speaker cable to the base.
A
Press the speaker
cable into the
base cover groove
as far as possible.
Bottom side of base
2kBrackets 8kRubber
pads
Bracket screws
Bracket
Screw head
Stoppers
Connection terminals
Rear of the speaker
Push!
B
Press the speaker
cable against the
base while
threading it
between the pegs.
Cable
RQT7921
5