Table of Contents
Advertisement
14
HOW TO USE
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that may have accumulated
during shipping.
y
y
Remove adhesive residue by wiping it off with your thumb or dishwashing detergent.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section. (Your plug type might be different from
the picture.)
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least three to four hours before putting food in
it. Check the flow of cold air in the freezer compartment to ensure proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The loudness will decrease as the temperature lowers.
Before Plugging in, open the refrigerator doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive
tape from inside the refrigerator and open the refrigerator doors for ventilation until
any odors have subsided.
CAUTiON
Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a flammable liquid or an abrasive when removing any tape
or adhesive from the refrigerator,.
Do not peel off the model or serial number label or the technical information
on the rear surface of the refrigerator.
NOTE
CAUTiON
Putting food in the refrigerator before it has cooled could cause the food
to spoil, or a bad odor could remain inside the refrigerator.
Advertisement
Table of Contents
