Filter Reset; Storage; Troubleshooting - Philips Dual Scan AC3854 User Manual

Filter reset

You can replace the filter even before filter replacement alert (
After replacing a filter, you need to reset the filter lifetime counter manually�
1
Touch the power
power socket�
2
Put the power plug in the power socket (fig
3
Within 15 seconds after power on, touch and hold
reset the filter lifetime counter (fig

6 Storage

1
Turn off the air purifier and unplug from the power socket�
2
Clean the air purifier, particle sensor and the surface of the filter (see chapter "Cleaning
and maintenance")�
3
Let all parts air dry thoroughly before storing�
4
Wrap the filter in air tight plastic bags�
5
Store the air purifier, filter in a cool, dry location�
6
Always thoroughly wash hands after handling the filter�
7

Troubleshooting

This chapter summarizes the most common problems you could encounter with the
appliance� If you are unable to solve the problem with the information below, contact the
Consumer Care Center in your country�
Problem
The appliance does
not work even though
it is plugged in�
The airflow that
comes out of the air
outlet is significantly
weaker than before�
button for 3 seconds to turn off the appliance and unplug from
)�
{
Possible solution
• The filter replacement alert has been on continuously but you
have not replaced the corresponding filter� As a result, the
appliance is now locked� In this case, replace the filter and long
press to reset the filter lifetime counter�
• The surface of the filter is dirty� Clean the surface of the filter (see
the chapter "Cleaning and maintenance")�
) displays on the screen�
)�
z
and button for 3 seconds to
EN
13