Advertisement
Carefully remove all parts from the box.
1. Begin by first installing the Spout.
a. Remove the Mounting Washers and Lock Nut (3, 4, 5) from the Spout (1).
b. Drop the Spout through the hole in your countertop or sink.
c. Tighten Lock Nut (4) against the underside of the mounting washers under the deck (3, 5).
2. Identify your Hot and Cold Valves.
a. Remove all trim from Valve Assembly (including Lock Nut where applicable), leaving Bottom
Lock Nut.
b. Push the valve from the bottom of the deck through the hole on the deck and thread the Lock
Nut onto the valve. Make sure the top of the Lock Nut is flushed with the end of cartridge
stem.
c. Put the entire handle trim onto the Top Lock Nut, make sure the broached hole on the handle
engages with the cartridge stem.
d. Thread the handle escutcheon onto the top locknut until it bottoms out to the deck.
e. Adjust position of handle then tighten the locknut on the valve.
3. Connect the two Flex Hoses to "T" Assembly and to the HOT and COLD valves, respectively.
These hoses can be bent or twisted but be careful not to kink the hoses or you will have
limited water supply and excessive noise from the faucet.
4. Begin by bleeding the water lines before connecting to the valves. Connect water supplies to
bottom of each valve.
5. Remove flow restrictors found in both inlets of "T" Assembly and flush faucet by running both
Hot and Cold water in fully open position. Replace the flow restrictors.
6. Check for leaks. If leaks or problems occur, re-tighten all nuts before consulting a plumber.
64-2-SPT-ASSY
64-2X-SPT-ASSY
Brut – Series 64 – Widespread Lavatory Set
Widespread Lavatory Set
Brut
Page 2
Advertisement
