What Do Do, If - AEG FAVORIT 54710 Operating Instructions Manual

What to do, if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer.
The dishwasher is fitted with a number of alarm systems which can help you to
quickly determine the cause of any problems.
The dishwasher will not start or stops during operation. All push buttons are
inoperative except for the On/Off push button. The indicator light of the programme
under and one or more of the phase indicator lights (Washing, Drying, End of
programme) are flashing.
Press the On/Off push button to switch off the dishwasher and carry out the
following suggested corrective actions listed below.
Fault code
...."washing" phase
indicator light is flashing
...."drying" phase indicator
light is flashing
...."washing" and "drying"
phase indicator lights are
flashing
....one or more phase
indicator lights are
flashing
Once the checks have been carried out switch on the dishwasher and start a washing
programme, if the fault code reappears in the digital display, contact your local
Service Force Centre.
Possible cause
The water tap is closed.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Remedy
Open the water tap.
Reposition correctly the
hose.
Reposition correctly the
drain hose. Follow the
instructions for connecting
to the waste.
Clear any blockages.
Close the water tap and
contact the Service Force
Centre.
Switch off the dishwasher.
Switch it back on and start
the programme.
if the alarm reappears, call
the Service Force Centre.
29