Connection - Panasonic TH-65XVS30UP Operating Instructions Manual

Connection

Note:
Please turn off the power of the Plasma Display unit and Digital Media Receiver when connecting or removing Display - Receiver cable.
Display connection
When connecting the speakers, be sure to use only the optional accessory speakers.
For details on installation and connection of the speaker, refer to the Speaker's Installation Manual. (Supplied)
Speakers (Optional accessories)
SPEAKER
Terminals (R)
– Cable fixing bands Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
DEDICATED RECEIVER IN
To DEDICATED DISPLAY OUT
connector on Digital Media Receiver
– AC cord fixing
2
1 . Connect the AC cord plug to the Plasma Display.
2 . Fix the left side clamper.
3 . Fix the right side clamper.
Note: The power plug in the illustration may not be the type fitted to your set.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
2
SPEAKER
Terminals (L)
Close
1
3
Open
To tighten:
Pull
1
2
1
2
Push until the hook clicks.
2. Pull off.
1. Keep the knob pressed.
To loosen:
Pull
Push the catch
SERVICE USE
These terminals are not in use.
11