Advertisement
PRECAUTIONS AND GENERAL GUIDELINES
This symbol is used to call your attention to hazards or unsafe practices which could result in an
injury or property damage. The signal word, defined below, indicates the severity of the hazard.
The message after the signal word provides information for preventing or avoiding the hazard.
WARNING
CAUTION
Read and understand all of the instructions and safety information in this manual
before operating or servicing this tool.
Wear eye protection when operating or servicing this tool.
Failure to wear eye protection can result in serious eye injury from flying debris.
Electric Shock Hazard:
This tool is not insulated. When using this unit on or near energized electrical lines,
use proper personal protective equipment.
Inspect the tool prior to use. Replace worn, damaged or missing components with replacement parts.
A damaged or improperly assembled tool may break. Use this tool for manufacturer's intended use
only. Use other than that which is described in this manual may result in injury or damage to the tool.
Do not add extensions (cheaters) to the handles. Using excessive force may result in injury or
damage to the tool. If excessive force is required to complete a punch, verify that the type and
thickness of material do not exceed the capacity of the tool.
Do not use on heavier than 20 gauge mild steel.
MSPT-1.3: PA26214A01_01
MSPT-1.3
Hazards which, if not avoided, COULD result in severe injury or death.
Hazards or unsafe practices which, if not avoided, MAY result in injury or
property damage.
WARNING
WARNING
WARNING
CAUTION
CAUTION
IMPORTANT INFORMATION
Page: 2 of 5
18-Sep-09
Advertisement
