Other Issues - Sony HMZ-T1 Reference Manual

HDMI Control
Symptom
Connected equipment
cannot be controlled using
the buttons on the head
mounted unit

Other Issues

Symptom
The power indicator keeps
flashing in red
When the system is off,
video and audio from the
playback equipment is not
played on a TV connected
to the HDMI OUT jack
"Control for HDMI" on a TV
cannot be used to control
the playback equipment
even when the system's
HDMI pass-through is used
Head mounted unit buttons
are unresponsive
Cause/Action
p Make sure the connected equipment supports the HDMI CEC
functions.
p Make sure "Control for HDMI" setting of the connected
equipment is configured correctly. For details, refer to the
instruction manual of the equipment used.
p The connected AV amplifier (receiver) may not be compatible
with the system's "Control for HDMI" function. "Control for
HDMI" function will not work correctly in this case.
p Controlling connected equipment by pressing buttons on the
head mounted unit may not be possible immediately after turning
the system on, or immediately after activating "Control for
HDMI" in "General Setup."
p Make sure the "Control for HDMI" setting in "General Setup" is
set to "On" (page 21).
Cause/Action
p If the indicator flashes twice every 3 seconds, the head mounted
unit or processor unit may be damaged. Contact your Sony dealer
or local authorised Sony service centre.
p If the indicator flashes three times every 3 seconds, the processor
unit has overheated. Wait until the unit cools off and flashing
stops. Make sure not to cover or obstruct the ventilation openings
of the processor unit for proper ventilation.
p If the indicator flashes four times every 3 seconds for a minute,
the head mounted unit has overheated. Wait until the unit cools
off and flashing stops.
p If the indicator flashes five times every 3 seconds for a minute,
both the head mounted unit and processor unit have overheated.
Wait until the units cool off and flashing stops.
p Confirm that the HDMI cables are fully connected.
p Set "HDMI pass-through" in "General Setup" to "On" (page 21).
p Switch the input source on the TV to this system.
p Check the HDMI output settings on the playback equipment.
p Refer to the instruction manual supplied with your TV, and in the
TV's "Control for HDMI" setting, specify this system as the
controlling device.
p Buttons on the head mounted unit do not function unless you are
wearing it.
GB
27