Table of Contents
Advertisement
3
Installation
To make the product ready for use, review the information in the user manual and
make sure that the electricity, tap water supply and water drainage systems are
appropriate before calling the Authorised Service Agent. If they are not, call a qualified
technician and plumber to have any necessary arrangements carried out.
DANGER!
Make sure that the installation and electrical
B
connections of the product are performed by
competent persons. Manufacturer shall not be held
liable for damages that may arise from procedures
carried out by unauthorised persons.
DANGER!
Your product is too heavy for one person to carry.
CAUTION
A
• Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
PRECAUTION
• Preparation of the location and electrical, tap water and
waste water installations at the place of installation is
A
under customer's responsibility.
• Make sure that the water inlet and discharge hoses as
well as the power cable are not folded, pinched or crushed
while pushing the product into its place after installation
or cleaning procedures.
3.1 Appropriate installation location
• Place the product on a solid and level floor. Do not place it onto a carpet with high
pile or other similar surfaces.
• Do not place the product close to the edge if the floor contains steps. Do not also
place the product on a platform.
• Do not place the product on the power cable.
• Do not install the product in environments where the temperature falls below 0
ºC.(See. Warnings for Drying)
• Place the product at least 1,5 cm away from the edges of other furniture.
In the area where this product is installed, there must not be a lockable, sliding or
hinged door that will restrict the full opening of loading door.
18 / EN
Washer-Dryer / User's Manual
Advertisement
Table of Contents
