Operation - Husky HOLT6202BJ2 Use And Care Manual

Assembly (continued)
12. Attach the front panel (N) to the drawer side panels (L) by using one
screw (AA) for each side.
AA
13. Using two or more people, stand the workbench in its upright
position.
14.
Install the drawers using the steps below
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper

operation.

N
15.
Remove the drawers using the steps below
□ Fully extend and empty the drawer.
□ Depending on the slide, either lift or lower the
release lever on both sides so the slides can ride over
the stops. Pull out to remove.
16. Install the crank handle (C) into the shaft in the corner below the
wood top as shown.
8