Tools You Will Need - GE 184-6C088-R1 Owner's Manual

Installation of the range.
Read these instructions completely and carefully.
WARNING!
Anti-Tip Bracket

Tools You Will Need

Phillips head screwdriver
" or adjustable wrench
1 ⁄
3
8
Flat blade screwdriver
Anti-Tip Bracket Installation Instructions
Anti-tip bracket attaches to the floor to hold either rear
range leg. When fastening to the floor, be sure that the
screw does not penetrate electrical wiring or plumbing. If
you cannot be sure of this, use a shorter screw that will not
penetrate through the flooring.
Decide whether the anti-tip bracket will be
installed on the right or left side of the range
location.
If the bracket side of the range is next to a
cabinet, place the bracket against back wall
and cabinet.
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) will be. Place the bracket with
its outside edge at this location and against
the back wall.
Outside edge of bracket
should be flush with the
outside of the range
14
• ALL RANGES CAN TIP
• INJURY COULD RESULT
• INSTALL ANTI-TIP DEVICE
PACKED WITH RANGE
• SEE INSTRUCTIONS
Wall behind range
Adjacent cabinet
or final location
of range side panel
Screw the bracket securely to the floor with
the screw provided. The screw is self-drilling
in wood, plywood, particle and chip board,
and most metal framing. If attaching to
masonry, you can buy suitable screws and/or
anchors at hardware stores. Use a masonry
drill to drill the required holes.
Anti-tip bracket
Using the wrench, back out the four range
legs at least two turns. Level the range. See
the Protect Your Floor and Leveling the Range
information in the Installation the range
section of this manual for leveling
information.
Slide the range into place.
Wall