Table of Contents
Advertisement
PL-8/PL-PLUS POWER CONDITIONER
PL-8 FEATURES
Two slide-out, swiveling light fix-
tures for rack illumination
Eight accessory outlets in rear,
controlled by a front panel switch
Triple mode varistor spike and
surge protection
RFI / EMI filtering
Circuit breaker, 15-amp rating
Dimmer control for lamp bright-
ness
Separate switch for lamps
Ten-foot, heavy duty 14-gauge AC
cord
PL-PLUS FEATURES
All PL-8 features, plus...
Line Voltage monitor reads 90 to
128 Volts
High performance RFI/EMI noise
filter
1
PL-8
The Furman PL-8 and PL-PLUS Power
Conditioners and Light Modules are the
perfect accessory for any rack-mount
system. lnstall a PL-8 in the top slot
of your rack, and the eight switched
AC outlets on the rear panel will power
up all your equipment while its two
slide-out light fixtures provide discreet
illumination of the controls on stages,
in studios, and in other dark places. A
dimmer control lets you adjust the lamp
brightness to just the right level.
The PL-8 protects your delicate
electronic equipment by combining
a high-voltage surge and transient
suppressor with an RFI/EMI
interference filter. The fast-acting
suppression circuit responds in
less than a nanosecond, clamping
transient voltages to safe levels. The
peak clamping voltage is 340 VAC,
effective for spikes on any of the three
AC conductors, and the clamping
circuitry can absorb a total of up to 240
Joules. These specifications indicate
a very high degree of protection when
compared with competitive products.
The filter works to prevent noise from
fluorescent lights, dimmers, radio
transmitters, and similar sources of
"electronic pollution" from contaminating
the AC line and from there, leaking
Hide quick links:
Advertisement
Table of Contents
