Removing The Freezer Drawer - LG LMXC23746 Series Owner's Manual

20 INSTALLATION
4
Reconnect the wire harness to the
connection at the end of the right rail by
aligning the two ends and pushing them
together until you hear a click. The tabs
should snap back into place. Tug gently to
make sure the connection is secure.
NOTE
If you do not reconnect the wire
harness securely, the CustomChill™
drawer will not work properly.
5
Pull the drawer open to full extension.
Lower the basket onto the rail system.

Removing the Freezer Drawer

CAUTION
Use two or more people to remove and
install the freezer drawer. Failure to do so
can result in back or other injury.
Do not hold the handle when removing
or replacing the drawer. The handle may
come off, causing personal injury.
Be careful of sharp hinges on both sides
of the drawer.
When you lay the drawer down, be
careful not to damage the floor.
Do not sit or stand on the freezer drawer.
To prevent accidents, keep children and
pets away from the drawer. Do not leave
the drawer open.
1
Pull the freezer drawer open to full extension.
2
Remove the top pullout drawer by first pulling
the drawer open to full extension.
On the left rail, use a flat blade screwdriver to
push in on the tab to release the drawer from
the rail, as shown below. Once the left side is
loose, push the tab on the right side with your
finger to release the drawer. Lift the front of
the drawer up, then pull it straight out.