Table of Contents
Advertisement
SAFETY PILOT
This fireplace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room fireplaces. The ODS/pilot
shuts off the fireplace if there is not enough
fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This sys-
tem requires no matches, batteries, or other
sources to light fireplace.
1. Remove fireplace and hood from carton.
Log is wrapped and inside fireplace. Do
not remove at this time.
2. Remove all protective packaging applied
to fireplace for shipment.
3. Make sure your fireplace includes one
hardware packet.
WARNING: Always have
branch support and screen in
place before operating fireplace.
This prevents excessive tem-
peratures on fireplace surfaces.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this fireplace may result in prop-
erty damage or personal injury.
ASSEMBLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
Installing Log
1. Lift screen up and pull out to remove.
2. Cut two plastic straps to remove the log
from the firebox cavity.
3. An optional blower is available. See Ac-
cessories, page 29. Install optional blower
now. Follow installation instructions pro-
vided with blower.
126871-01A-01
PRODUCT FEATURES
UNPACKING
ASSEMBLY
www.SuperiorFireplaces.US.com
THERMOSTATIC HEAT CONTROL
This fireplace has a thermostat sensing bulb
and a control valve. The thermostat will auto-
matically modulate the heat output to maintain
a consistent room temperature. This results in
greater fireplace comfort. This can also result
in lower gas bills.
4. Check fireplace for any shipping damage.
If heater is damaged call INNOVATIVE
HEARTH PRODUCTS at 1-800-655-2008
for replacement parts before returning to
dealer.
4. Remove log packaging material and
discard packaging. Gently place log set
on burner support (see Figure 2). The log
should fit flat against top of burner support
and log locator tabs fit into the slots under
the log. Do not allow log to contact flame.
If flame contacts log, soot will be created.
5. Reattach screen by placing the notches
in the screen frame over the shoulder
screws and pushing down.
Assembling Hood
Shoulder
Log
Screw
Screen
Figure 2 - Assembling Fireplace
Burner Support
with Log
Locator Tabs
Branch
Support
5
Advertisement
Table of Contents
