Care And Maintenance - Fujitsu Plasmavision PDS4204 User Manual

CARE AND MAINTENANCE

BEFORE CLEANING
Always unplug the power cord from the
socket.
Cleaning the cabinet and remote controller
Do not use benzene, paint thinner, or other solvents. They
can cause deterioration or paint peeling on the cabinet,
the screen front filter, or the remote controller.
Wipe gently with a soft cloth.
BEFORE REQUESTING REPAIR
If you think a malfunction may have occurred, check the following items.
When this happens
• The power does not come on.
• The picture dose not appear.
• The remote controller does not work.
• There is a creaking sound.
• There is a humming sound.
• There are dots on the screen.
• The colors and tints are not good.
• There is no sound.
• ERROR MESSAGE CONDITION 1 is displayed.
• ERROR MESSAGE CONDITION 2 is displayed.
• INVALID CARD is displayed.
• NO CARD is displayed.
• DATA READING ERROR is displayed.
52
For stubborn grime, soak the soft cloth in neutral cleaning
agent diluted with water, wring it out well, and wipe clean.
Then, finish with a dry, soft cloth.
Cleaning the screen
Wipe gently with a soft cloth.
The surface of the screen is easily scratched, so do not
strike it or rub it with anything hard.
• Is the power cord disconnected?
• Is a cable to other equipment disconnected?
• Are the batteries installed with their poles reversed?
• Are the batteries flat?
• Are you operating from far away?
• Are you trying to operate with the transmitting section of the
remote controller not facing the reception section of the
display?
• Is there any obstruction between the display and the remote
controller?
• This sound is generated by the expansion and contraction of
the cabinet owing to change in the room temperature.
• The Plasmavision has heat radiation fins to prevent its internal
temperature from rising too high during operation. The sound
you hear is the fan rotating.
• Is the connected tuner being affected by interference from a
car, train, high-voltage line, neon light, or the like?
• Do any of the video settings need readjusting?
• Are the internal speakers switched off?
• The fan is malfunctioning. Switch off the power.
• The temperature inside the set has risen far too high.
Switch off the power. (The power can be turned on once the
temperature lowers.)
• Is the inserted PC card the correct type?
Use the recommended PC card.
• Are you attempting operation without any PC card in the
PC card slot?
• Data of the PC card cannot be read. Check that the data used
by the "program creation software" is correct.
Check