Fujitsu Plasmavision PDS4204 User Manual page 16

USING PC CARD
Rear
How to load and unload the
PC card
Open
Front side
Arrow indicating
loading direction
Insert PC card.
Do not insert it back to front.
16
PREPARATION
• To use your purchased PC card, first initialize your personal computer again
(format compatible with MS-DOS (R)).
This initialization need be done once only.
1
Creating programs on the PC card is done using the
accessory program creation software.
Refer to the PC cards operation manual for how to initialize the PC card
and how to create and save programs on the PC card.
2
Loading/unloading the PC card
• Switch on the Plasmavision's power.
If the power lamp is lit (red or green), press the power switch at the rear
to turn off the power. Confirm that the power lamp is not lit.
• Open the door to the PC card slot on the side of the Plasmavision.
• When loading the PC card, insert the PC card into the PC card slot.
Insert the PC card for creating or storing programs with the
accessory program creation software.
• Push the PC card right into the slot until the button on the side of the card slot
pops up.
• Confirm that the PC card is inserted completely, and close the door of the PC
card slot.
• Lock the door with the accessory key (to prevent theft of the PC card).
CAUTION
• Do not insert your finger or any other object into the PC card slot
when loading or unloading the PC card.
• Do not insert the PC card back to front. Also, do not insert the
PC card at an angle or use excess force to push it in.
• When loading or unloading the PC card, be sure that the power
switch of the Plasmavision is off.