Fujitsu Plasmavision P42HCA10UH User Manual page 21

• Contrast, brightness, color darkness, tint, and picture sharpness are adjusted as shown in the following chart.
Select the item with , and then adjust with
Adjustment Item
Contrast
Brightness
Color
Tint
Sharpness
• Setting Picture Mode (Picture Mode)
Can set up the picture mode.
Each time you press or , one of the available choices appears in the following sequence:
Dynamic: Suitable for watching a normal motion picture.(Standard)
Real: Makes a strong contrast picture.
Static: Suitable for watching a still picture.
Press to store.
* Select Dynamic, Real or Static to suit your taste.
• Setting Luminance
Luminance can be set.
Use or to select a value between 40 and 100.
Press to store.
* Settings can only be done when the Picture Mode is Static.
• Adjusting Color Temperature (Color Temp.)
Use or to specify a desired color temperature. Each time you press
available choices appears in the following sequence:
–3500: More reddish colors
Standard: Standard color temperature
+3500: More bluish colors
User: User Color Temp. setup
Press to store.
• Setting User Color Temp. (User Color Temp.)
Can set up when User is selected in Color Temp.
Press or to select Red, Green or Blue and press
of 0 to 255.
Press to store.
* Color Temp. setup is switched to User. The initial value of User Color Temp. is adjusted
individually at the factory.
* On-screen information disappears if you do not take any action for about 60 seconds.
. Finally, press
Lower contrast
Darker screen
Lighter colors
More purplish colors
Softer pictures
or to make adjustment in the range
to implement the adjustments.
Higher contrast
Brighter screen
Darker colors
More greenish colors
Sharper pictures
or , one of the
User Color Temp.adjustment screen
Adjustment Range/Remarks
–30 to +30
–60 to +60
–60 to +60
–60 to +60
–4 to +4
E-21