Table of Contents
Advertisement
Requirement: The laundry is pre-
pared.
→ "Laundry", Page 30
Open the door.
1.
Make sure that the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.4 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Nachlegen.
▶
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: "End".
12.5 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press Start/Nachlegen.
1.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→ "Display", Page 20
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Nachlegen.
5.
12.6 Cancelling the pro-
gramme
Press Start/Nachlegen.
1.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→ "Display", Page 20
Open the appliance door.
2.
Remove the laundry → Page 31.
3.
12.7 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
12.8 Switching off the appli-
ance
Turn the programme selector to
▶
Aus.
12.9 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note: If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Requirements
¡ The display shows the following
after drying: "End"
¡ or during operation:
Open the door.
1.
operation en
.
31
Advertisement
Table of Contents
