Advertisement
Cream Dispenser
Model SKMCD1P/C1
Calibration of dispense volumes on McDonald's Creamers SKMCD1P
*Always perform calibration checks with new bag of cream and after pressing REFILL
button for 3 seconds
For units with serial numbers prior to SAHG (with J Hook)
1.
Install new bag of cream
2. Press and hold refill button for 3 seconds (display should flash 00)
3. Place cup under dispenser
4. Press 1 small, 2 medium and 1 large shot
5. Total dispensed should be 3 ounces. (/8 ounce for 1 shot)
6. If not correct, then pull screw out past J Hook as far as it will go
7. Measure distance from J Hook to head of screw
8. Adjust to the distance = ¾"
9. If still off, contact tech support at 800-329-3329 (Call while in front of the machine and
provide serial number)
NOTE: Do not attempt to adjust controller in programming. Discrepancy of dispense
volume is caused by mechanical issue, not programming)
For units with serial numbers after SAHJ (with cotter pin style – No J Hook)
1.
Install new bag of cream
2. Press and hold refill button for 3 seconds (display should flash 00)
3. Place cup under dispenser
4. Press 1 small, 2 medium and 1 large shot
5. Total dispensed should be 3 ounces (3/8 ounce for 1 shot)
6. If not correct, then call technical support at 800-328-3329 (call while in front of machine
and provide serial number)
NOTE: Do not attempt to adjust controller in programming. Discrepancy of dispense
volume is caused by mechanical issue, not programming)
46800 SKMCD1P/C1 - PM
Advertisement
