Table of Contents
Advertisement
StreamEnjin User Manual
No.
Component
6
Transition
Control
24
Controls the switching between the current stream (PGM)
scene and the preview (PRV) stream.
To switch,
1. slide the transition bar all the way to the top or bottom; or
2. tap the Cut
3. tap the Auto
Using the Transition Bar
When using the transition bar, the scene transition speed
depends on how fast you slide the bar.
You can create different effects by sliding it slowly, quickly or
even hold it half way.
Using the Cut button
The transition happens immediately when you tap the Cut
button.
Using the Auto button
Tapping the Auto button will begin the transition after a
specified time (0.3-3.0 seconds). Go to the Setting Deck and
refer to page 37 on how to modify this specified time.
Quick Mode
Tap
to start Quick Mode (
During Quick Mode, PRV preview disappears and you can tap
any of the scenes to broadcast the scene as the PGM
preview.
Two Quick Modes are available: Tap
Mode" (
) or tap
Under Cut Quick Mode, tapping a scene will instantly
broadcast that scene as the PGM preview.
Under Auto Quick Mode, tapping a scene will broadcast that
scene after the specified time (0.3-3.0 seconds).
Tap
or
, or tap
(
).
Description
button; or
button.
for "Cut Quick
for "Auto Quick Mode" (
again to exit Quick Mode
).
).
Advertisement
Table of Contents
