Operation Method - Zokop YPS5-12C User Manual

Cool mode
· When the A/C enters cooling mode automatically or cooling mode is selected after
power ON, the cooling indicator lamp lights up.
Press Up/Down key to adjust setting temperature (60.8 F ~ ~ 86 ) .
·
Press Speed key to choose High/Mid/Low speed.
·
Fan mode
·
When pressing mode key or choosing Fan mode by pressing the remote controller,
the wind indicator lamp lights up.
·
Press Speed key to choose High/Mid/Low speed.
Temperature can't be set.
·
Dry mode
When pressing mode key or choosing dry mode by pressing the remote
·
controller, the dehumidification indicator lamp lights up.
·
Take off the water plug of the desiccant nozzle as shown on the right, insert the water
guide pipe, and put the other end of the water guide pipe into the water container
or drainage channel.
When entering the dry mode, the
·
the room temperature is greater than 63 F Thereafter
the compressor is controlled according to the
following rules: when the room temperature is
。
less than 59 F, the compressor is turned off;
when the room temperature is raised to
。
more than 59 F, the compressor is restarted
(the compressor restart must satisfy the three-minute
delay protection function).
In dehumidification mode, the fan is defau l t ed to run at low speed,
·
and wind speed can't be adjusted
Temperature can't be set.
·
Use hint: when dry function is used, the exhaust pipe assemblyshould be
removed,otherwise it will cause that dehumidification effect is notobvious
and "FL" full of alarm display appears.

OPERATION METHOD

compressor is
。
14
。 。
F
started if