Advertisement
ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
Antenna connector
To subwoofer (see diagram
Rear ground terminal
Line out (see diagram
)
To external components (see diagram
*
2
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
White with black stripe
White
Left speaker (front)
B
Connecting the external amplifiers and/or subwoofer
You can connect amplifiers to
Rear speakers
upgrade your car stereo system.
• Connect the remote lead (blue
with white stripe) to the remote
JVC Amplifier
lead of the other equipment so
that it can be controlled through
this unit.
• Disconnect the speakers from
Front speakers
this unit, connect them to the
amplifier. Leave the speaker
leads of this unit unused.
JVC Amplifier
C
Connecting the external components
®
CD changer, Apple iPod
, or JVC D. player
• Set "CHANGER" for the external input setting (See page 14 of the INSTRUCTIONS.)
You can connect these components as illustrated below. The iPod*
can be connected using an interface adapter (not supplied)—KS-PD100 (for
iPod) or KS-PD500 (for D. player).
CD changer jack
Other external component
• Set "EXT IN" for the external input setting (See page 14 of the INSTRUCTIONS.)
CD changer jack
)
15 A fuse
Black
*
2
Yellow
Red
)
Blue
Blue with white stripe
Orange with white stripe
Brown
Gray with black stripe
Gray
Right speaker (front)
Remote lead
Remote lead (Blue with white stripe)
5
or D. player
or
JVC CD changer
External
component
3.5 mm stereo mini plug
*
1
Not supplied for this unit.
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car
battery (bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA
max.)
To the remote lead of other equipment (200 mA max.)
To car light control switch
To cellular phone system
Green with black stripe
Green
Left speaker (rear)
Y-connector (not supplied for this unit)
To the remote lead of other equipment or automatic antenna if any
Front speakers
Apple iPod
(separately purchased)
JVC D. player
(separately purchased)
External
component
2
Ignition switch
Fuse block
Purple with black stripe
Purple
Right speaker (rear)
*
3
Firmly attach the ground
wire to the metallic
body or to the chassis
of the car—to the place
uncoated with paint (if
JVC Amplifier
coated with paint, remove
Subwoofer
the paint before attaching
the wire). Failure to do so
may cause damage to the
unit.
*
4
Signal cord (not supplied for this unit)
CAUTION:
• Before connecting the external components,
make sure that the unit is turned off.
*
5
iPod is a trademark of Apple Computer, Inc.,
registered in the U.S. and other countries.
*
6
Connecting cord supplied for your CD changer
*
7
Line Input Adapter KS-U57 (not supplied for this unit)
*
8
AUX Input Adapter KS-U58 (not supplied for this unit)
Advertisement
